Spadeit forums

just my opinion

I'm using the very latest telescope (1.52b I think) and I notice if I start a scan, a few tables appear in upper pane, I then hit "cancel" and it clears away everything from the upper pane.

sometimes I may spot a tbl I want to look at before full scanning is done, telescope is interfering with my mouse and clicking, so I hit "cancel" to use my mouse, but now the tbl I wanted to check out is gone because I hit "cancel"

actually I just noticed something else may be going on and maybe it's not "cancel" that's clearing the window.

I did a full scan with some "adv filter" options, players between 2-5, a bunch of tables showed up in the pane while scanning, then once scan finished everything disappeared.

then I open "filter", deselected "adv filter" and a bunch of tables instantly appeared in the upper pane. and there were so few tables I'm pretty sure they were just the tables done from that filtered full scan.

then I opened the filter again, selected the "adv filter" chkbox and everything disappeared again.

so while scanning it displays tables based on "players between ..." then when scan is done (or I hit "cancel") it applies the "adv filter" stuff only leaving what matches? if "yes" then you can ignore this thread I thought it was applying all the filters to each table and only displayed ones that matched, not that it was doing the filtering in steps. sorry.

Yes it's like you described

After scanning (no matter if scan finished or cancelled) the "advanced" and "overall" filter gets applied....
Leaving only the tables that meet the filter...

So if all tables disappear when hitting "Cancel" then it the "advanced" and "overall" filters fault.